Pse-archery Compound Bow Set-up Procedures Bedienungsanleitung PDF herunterladen

Compound Bow Set-Up & Tuning Procedure

Rev 02/12/08

1. Remove bow from shipping box. Remove bow from plastic bag and remove the owner’s guide and other

promotional material from the bow.

2. Read the Owner’s Guide before using the product.

3. Inspect the bow to insure that the cables and string are in their tracks on the cam and attached to the posts

properly. Check all screws and bolts to insure they are not loose, including rubber dampers and cam

modules and/or inner cams.

4. Set Draw weight: Adjust draw weight to the desired level by turning the limb bolts clockwise to increase

weight and counter-clockwise to decrease weight. Turn both limb bolts equal amounts for the initial setting.

5. Set tiller: Check tiller before making any other adjustments. The distance from the riser to the string, as

shown in the photo below, should be the same for both the top and bottom limbs. If the distance is the

same, no adjustment is required. If the distance varies more than 1/8”, adjust the limb bolts the same

amount in OPPOSITE directions until the tiller is correct. For example, if the top limb bolt is turned

clockwise a half a turn, the bottom limb bolt must be turned counter clockwise a half a turn. For One-Cam

bows, the tiller must be measured by tying a thin piece of string from one axle to the other and using that

string to measure tiller.

1 2 3 4 5 6 7 8

Seite 1

Compound Bow Set-Up & Tuning ProcedureRev 02/12/08 1. Remove bow from shipping box. Remove bow from plastic bag and remove the owner’s guide and

6. Checking static cam orientation: With the bow at rest, generally the cam orientation marks on the cam should be within a string width of being on

10. For all styles of arrow rests set the center shot adjustment on the rest so that the arrow is parallel to the alignment mark. 11. Using the no

Seite 4

13. For a fall-away rest: • Tightly serve an area on the downward-traveling buss cable going down a minimum distance of 1¼” starting 1½” below the s

Seite 5

17. Install the sight following carefully the instructions provided with the sight. Some bows are equipped with multiple holes for mounting the sight

20. Install the sling and stabilizer. 21. Recheck all screws and bolts to insure tightness.   

Low Tear: If the fletched end of the arrow tears the paper below where the tip penetrates. This may indicate that: • Nocking point too low: Place noc

FINE TUNING Paper tuning the bow is a good starting point. The bow is not truly tuned until it groups. To add a final “fine” tune to the bow: • At 20

Keine Kommentare

Pse-archery Compound Bow Set-up Procedures Bedienungsanleitung